FA-HUD-V13 High Definition OBD-II HUD Head Up Display for Car



    FA-HUD-V13 High Definition OBD-II HUD Head Up Display for Car


    1, Introduction of the product:

    The purpose of this product is to avoid the accident caused by the driver looking down at the instrument display while driving, and to keep the driver in the best driving state. This is a new high-tech product of virtual imaging, which mainly displays the engine RPM and speed of the vehicle. The imaging distance is 1.5 meters and the imaging size is 4.5 inches.


    2, Supported OBD-II Protocols:

    SAE J1850 PWM41.6 Kbaud

    SAE J1850 VPW10.4 Kbaud

    ISO 9141-25 baud init,10.4 Kbaud

    ISO 14230-4 KWP5 baud init,10.4 Kbaud

    ISO 14230-4 KWPfast init,10.4 Kbaud

    ISO 15765-4 CAN11bit ID,500 Kbaud

    ISO 15765-4 CAN29bit ID,500 Kbaud

    ISO 15765-4 CAN11bit ID,2500 Kbaud

    ISO 15765-4 CAN29bit ID,250 Kbaud


    3, Product Features:

    Image rendering: only vehicle speed and engine RPM are displayed.

    The synthetic imager uses manual adjustment to adjust the angle of the synthetic image so as to achieve the best image effect.

    The light sensitivity has a standard value, allowing users to adjust the brightness to increase or decrease by 20%.

    It is not dazzling during driving.

    HD display.

    Lossless installation.

    Plug and play.


    4, Main Components:

    HUD main machine

    Conversion cable

    OBD adapter

    Adjusting bracket

    Bracket pad

    User manual

    Color box


    5, Technical Parameters:

    Main control chip: R8F5SA6

    Imaging range: 1.5m

    Imaging size: 4.5 inches

    Working voltage: DC 9-16V

    Working current: 80mA

    Operating temperature: -20-65

    Storage temperature: -30-80

    Product dimension: 116*74*25mm


    6, Installation Guide:

    Match and adjust gaskets and brackets and so on according to the difference requirement of driver and vehicle type, the purpose is to make the driver feel the best. When the vehicle is under flameout state, connect and link all components, connect the 5PIN end of the conversion cable to the HUD, and the OBD end to the OBD socket of the car. Tidy the cable if it is necessary.


    Fix the matched gasket on the HUD, and then fix it in the right position on the car. Ignite the car and start to adjust the angle of the lens, try to get best display effect of the HUD and then you can start to use it.

Copyright © 2008 - 2019 FIBERALL TECHNOLOGY LIMITED All Rights Reserved